BROADCOM NETXTREME 57XX GIGABIT CONTROLLER VLAN DRIVER

Ensure there is network connectivity between the team and the probe target on the untagged VLAN. The range is Consequently, the adapter that was initially designated a load balance member remains in an inactive state and becomes the new standby member. Determines if your network cable is too long for optimum network performance. Broadcom Advanced Control Suite 2 Overview.

Uploader:	Kazrakazahn
Date Added:	12 May 2007
File Size:	49.20 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	91976
Price:	Free* [*Free Regsitration Required]

If the link partner is not correctly configured for IEEE A count of the frames that were delayed being transmitted on the first attempt because the medium was busy. To view this information for any team netxtremf adapter, click the name of the adapter. You must have administrator privileges to change the values for a property.

If you attempt to use a team name more than once, an error message is displayed indicating that a team by that name already exists. Teaming is done through the Broadcom Advanced Server Program software. Every adapter in the network must have its own unique MAC address. To specify different values, click the desired probe interval in the Probe interval seconds list and click the desired maximum number of probe retries in the Probe maximum retries list. The configuration file is a text file that can be viewed by any text editor.

This counter is incremented when the transmit status is reported as Transmit OK, and the value of the attempts variable is greater than 2 and less than or equal to the attempt limit.

The Advanced tab allows you to view and change the values of the available properties of the selected adapter. Auto is the recommended setting. Information about network adapters made by others is less comprehensive than the information provided for Broadcom network adapters.

A probe target must be on the same subnet as the team, have a valid not a broadcast, multicast, or unicaststatically-assigned IP address, and be highly available always on.

windows 7 - Configure multiple VLAN on a Broadcom NetXtreme 57XX adapter - Super User

Team statistics are not compiled for a Broadcom network adapter if it is disabled. To maintain optimum adapter performance, your system should have 64 MB of system memory for each of the 8 VLANs created per adapter. PAUSE frame receipt and transmission are disabled. Team names must be unique.

802.1q support for broadcom netxtreme 57xx gigabit controller

To perform a silent install or upgrade from within the installer source folder. The port number of the adapter. If the adapter nehxtreme shows a superimposed running yellow figure, the adapter is connected and participating in the team correctly, which corresponds to an Active BASP state.

The team bradcom cannot exceed 39 characters, cannot begin with spaces, and cannot contain any of the following characters: Select the Enable LiveLink check box. You must have administrator privileges to perform diagnostics. VLANs can only be created when all team members are Broadcom adapters.

Ensure there is network connectivity between the team and the probe target on the nroadcom VLAN. The standby member does not actively send and receive normal network traffic while other adapters on the team are active.

A new virtual adapter is created for each VLAN. The link speed of the adapter. If you are not satisfied, either delete the team, or reconfigure it. The list of available properties is different on some models of the Broadcom NetXtreme Gigabit Ethernet adapters than on others.

A count of frames that were successfully transmitted as indicated by the transmit status Transmit OK to the broadcast address. Wait for the install to complete before continuing with the next command.

Click Yes when the message is displayed indicating that the network connection will be temporarily interrupted. Click the type of team, and then click Next.